AOS-CX 10.07 Multicast Guide Help Center
Configuring join/prune interval
Configure the interval at which the router will send periodic PIM-SM join or prune interval messages.
Prerequisites
You must be in the PIM configuration context, as indicated by the switch(config-pim)# prompt for IPv4 or the switch(config-pim6)# prompt for IPv6.
Procedure
Configure the join/prune interval using the following command.
join-prune-interval <INTERVAL-VALUE>
For example, the following command sets the join/prune interval to 400 seconds:
For IPv4 configurations:
switch# configure terminal
switch(config)# router pim
switch(config-pim)# join-prune-interval 400
For IPv6 configurations:
switch# configure terminal
switch(config)# router pim6
switch(config-pim6)# join-prune-interval 400
The no form of the command sets the interval to the default of 60 seconds.
