Legal Disclaimer: The resource assets in this website may include abbreviated and/or legacy terminology for HPE Aruba Networking products. See www.arubanetworks.com for current and complete HPE Aruba Networking product lines and names.
ArubaOS 8.11.1.0 Help Center
AOS-8 Getting Started
This section provides an overview on how to install the Mobility Conductor and managed devices.
Perform the following steps to install the Mobility Conductor and managed devices:
- Launch the WebUI or Console Setup Wizard to configure the managed device.
- Connect the managed device to the wired network.
- Configure the managed device to the Mobility Conductor. The Mobility Conductor - Managed Device topology or stand-alone controller topology is supported.
- If it is a stand-alone controller deployment, installing the Mobility Conductor is not required.
- Install and connect your APs to the network.
Setting up Your Devices
Get started with setting up the Mobility Conductor, Managed Device or Stand-alone Controller. See the illustration below and follow the instructions.
