Configuring RRM IE Profile

HPE Aruba Networking Central supports the Radio Resource Management Information Element (RRM IE) profiles advertised by the AP. The RRM IE signal supports for the radio measurements in a device. The clients use this IE to specify their radio measurement capabilities. The RRM IE profiles are available only for 6 GHz Gigahertz. radio profiles. You can assign the RRM IE profiles to the radio profiles on the Radios > RF Radio Frequency. RF refers to the electromagnetic wave frequencies within a range of 3 kHz to 300 GHz, including the frequencies used for communications or Radar signals. > Radio WebUI page. For more information, see Configuring Radio Parameters.

To configure RRM IE profiles, complete the following steps:

1. In the WebUI, use the filter to select a group or a device.
2. Under Manage, click Devices > Access Points.
3. Click the Config icon.
   The tabs to configure access points is displayed.
4. Click Show Advanced, and click Services.
   The Services page is displayed.
5. Click RRM IE Profile accordion.

   The RRM IE profile table is displayed.

6. Click + on the RRM IE profile table.

   The RRM IE profile configuration window is displayed.

7. Configure the following parameters:
   1. Name—Enter the name for the RRM IE profile.
   2. Country—When enabled the AP will advertise in beacon and probe responses the device's regulatory domain.
   3. Enabled Capabilities—When enabled the AP will advertise in beacon and probe responses support for radio measurements in a device.
8. Click OK.
9. Click Save Settings.