Legal Disclaimer: The resource assets in this website may include abbreviated and/or legacy terminology for HPE Aruba Networking products. See www.arubanetworks.com for current and complete HPE Aruba Networking product lines and names.
AOS-CX Configuration Using Templates
Templates in HPE Aruba Networking Central refer to a set of configuration commands that can be used by administrators for provisioning devices in a group. Configuration templates enable administrators to apply a set of configuration parameters simultaneously to multiple switches in a group and thus automate switch deployments.
- To minimize configuration errors and troubleshoot device-specific configuration issues, HPE Aruba Networking recommends that the device administrators familiarize themselves with the CLI configuration commands available on AOS-CX switches.
- The configuration-lockout central managed configuration line is necessary to lock the switch against configuration changes made outside of HPE Aruba Networking Central.
- When importing the running configuration of an AOS-CX switch to HPE Aruba Networking Central using template configuration, the original running configuration that was present on the device when it was onboarded will be used. Any changes made to the running configuration after initial onboarding of the AOS-CX switch will not be reflected in the import running configuration feature.
- The
vsf member 1
line must be present in the configuration template for stackable AOS-CX switches running 10.07 or later versions. This is required to apply configuration to the switches. In case, if a template is applied to the switch that does not contain thevsf member 1
line, then the switch will be zeroized.
For template-based provisioning, switches must be assigned to a group with template-based configuration method enabled.
When firmware compliance is set for a template group, then the template configuration push will be blocked on all non-compliant devices. The configurations will be pushed to these devices only when a compliant build firmware is downloaded and when the devices are rebooted.
For more information, see Managing Groups and Assign Devices to Groups.
The AOS-CX switches running firmware version 10.06 or later.
feature is supported only on