Legal Disclaimer: The resource assets in this website may include abbreviated and/or legacy terminology for HPE Aruba Networking products. See www.arubanetworks.com for current and complete HPE Aruba Networking product lines and names.
Aruba Central Online Help
Using Command in the Gateway's Local Configuration
Using the disaster-recovery on command allows you to enable the config mode and edit the configuration in the HPE Aruba Networking Central local Gateway-node.
To make changes to the configuration that enables communication between the gateway and HPE Aruba Networking Central, complete the following steps:
- Verify that the configuration sent to the gateway allows communication with HPE Aruba Networking Central, by executing a show -central details from the CLI.
- In HPE Aruba Networking Central CLI, execute show configuration effective <path to local-node of Gateway> command.
- When you turn disaster-recovery off using the disaster-recovery off command, the gateway contacts HPE Aruba Networking Central again and synchronizes the configuration.
If HPE Aruba Networking Central reverts to the earlier non-functional state, recheck and test the configuration used.
